======================================================================
  Microsoft(R) Product Support Services Application Note (Text File)
     WG0971: NDIS2SUP.386 CORRECTS PROBLEMS RESTARTING WINDOWS FOR
                   WORKGROUPS ON TOKEN RING MACHINES
======================================================================
                                                  Revision Date: 12/93
                                                       1 Disk Included

The following information applies to Microsoft Windows(TM) for
Workgroups, version 3.11.

-----------------------------------------------------------------------
| INFORMATION PROVIDED IN THIS DOCUMENT AND ANY SOFTWARE THAT MAY     |
| ACCOMPANY THIS DOCUMENT (collectively referred to as an Application |
| Note) IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER      |
| EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED      |
| WARRANTIES OF MERCHANTABILITY AND/OR FITNESS FOR A PARTICULAR       |
| PURPOSE. The user assumes the entire risk as to the accuracy and    |
| the use of this Application Note. This Application Note may be      |
| copied and distributed subject to the following conditions:  1) All |
| text must be copied without modification and all pages must be      |
| included;  2) If software is included, all files on the disk(s)     |
| must be copied without modification (the MS-DOS(R)  utility         |
| diskcopy is appropriate for this purpose);  3) All components of    |
| this Application Note must be distributed together;  and  4) This   |
| Application Note may not be distributed for profit.                 |
|                                                                     |
| Copyright (C) 1993 Microsoft Corporation.  All Rights Reserved.     |
| Microsoft and MS-DOS are registered trademarks and Windows is a     |
| trademark of Microsoft Corporation.                                 |
| IBM is a registered trademark of International Business Machines    |
| Corporation.                                                        |
-----------------------------------------------------------------------

Introduction
------------

You may have problems quitting Windows for Workgroups version 3.11 on
systems using the NDIS version 2 IBM(R) token ring driver
(IBMTOK.DOS). If you run, quit, and then restart Windows for
Workgroups (without restarting the computer), the computer usually
stops responding (hangs). With this driver, you may also notice that
your video display is reset after you quit Windows for Workgroups. For
example, if your video display is set to 50-line mode before you run
Windows for Workgroups, it may be reset to 25-line mode after you
quit.

The WG0971 disk included with this Application Note contains a new
NDIS 2.0/3 support layer file (NDIS2SUP.386) to correct these
problems.

To install the new NDIS2SUP.386 file
------------------------------------

1. Insert the enclosed WG0971 disk in the appropriate floppy disk
   drive.

2. To copy the file to the Windows SYSTEM directory, type the
   following at the MS-DOS command prompt and then press ENTER

      copy <drive>:\ndis2sup.386 <destination>

   where <drive> is the floppy disk drive containing the WG0971 disk
   and <destination> is the drive and directory of your Windows SYSTEM
   directory.

   For example, if the WG0971 disk is in drive A and your Windows
   directory is C:\WINDOWS, type the following at the MS-DOS command
   prompt and then press ENTER:

      copy a:\ndis2sup.386 c:\windows\system